中国半导体行业协会封装分会会刊

中国电子学会电子制造与封装技术分会会刊

导航

电子与封装 ›› 2022, Vol. 22 ›› Issue (6): 060304 . doi: 10.16257/j.cnki.1681-1070.2022.0613

• 电路与系统 • 上一篇    下一篇

装载操作系统国产化板卡复位系统的研究

宁东平;张志强;黄茨   

  1. 中科芯集成电路有限公司,江苏 无锡 214072
  • 收稿日期:2021-10-21 出版日期:2022-06-23 发布日期:2022-01-25
  • 作者简介:宁东平(1988—),男,四川巴中人,硕士,工程师,现从事硬件电路设计工作。

Research on the Reset System of Localized Board Loadedwith Operating System

NING Dongping, ZHANG Zhiqiang, HUANG Ci   

  1. China Key System & Integrated Circuit Co., Ltd., Wuxi 214072, China
  • Received:2021-10-21 Online:2022-06-23 Published:2022-01-25

摘要: 针对装载操作系统国产化板卡应用时对复位系统的要求,设计了一种复位电路。采用定时器、看门狗与缓冲器的架构,满足国产化板卡加载系统时系统复位信号一直保持高电平的需求。在系统加载完成后,CPU输出喂狗信号,复位系统监控CPU运行。一旦出现死机的情况,CPU被复位,重新加载系统。通过原理分析、电路设计以及原理验证板测试,验证了复位系统设计的合理性与可行性。

关键词: 国产化板卡, 看门狗, 定时器, 复位系统

Abstract: A reset circuit is designed to satisfy the requirements of the reset system when the operating system is loaded with localized boards. The architecture of timer, watchdog and buffer is adopted to meet the requirements that the system reset signal must keep a high level when the localized board is loaded into the system. After the system is loaded, the CPU outputs the dog feeding signal, and the reset system monitors the operation of the CPU. Once the crash occurs, the CPU is reset, and the system is reloaded. Through principle analysis, circuit planning and principle verification board test, the rationality and feasibility of the reset system design are verified.

Key words: localizedboard, watchdog, timer, resetsystem

中图分类号: