中国半导体行业协会封装分会会刊

中国电子学会电子制造与封装技术分会会刊

导航

电子与封装 ›› 2019, Vol. 19 ›› Issue (4): 019 -23. doi: 10.16257/j.cnki.1681-1070.2019.0040

• 电路设计 • 上一篇    下一篇

一种高速高精度AB类全差分运算放大器的设计

张 镇,王雪原,冯 奕   

  1. 中国电子科技集团公司第五十八研究所,江苏 无锡 214072
  • 收稿日期:2018-11-28 出版日期:2019-04-20 发布日期:2020-01-16
  • 作者简介:张 镇(1992—),男,江苏泰州人,硕士学历,2018年毕业于南京理工大学集成电路工程专业,射频IC工程师,现从事射频IC设计。

Design of a High Speed and High Accuracy Class-AB Fully Differential Operational Amplifier

ZHANG Zhen   

  1. China Electronics Technology Group Corporation No.58 Research Institute, Wuxi 214072, China
  • Received:2018-11-28 Online:2019-04-20 Published:2020-01-16

摘要: 通过对传统两级单端运放结构的改进,设计了一种AB类输入和输出的全差分运放,在不损失增益的前提下提高了带宽和压摆率。本运放基于JAZZ 0.18 μm CMOS工艺进行设计,为了保证设计的鲁棒性,仿真覆盖了全工艺角,结果表明,在3.3 V 10%的电源电压、5 pF的大负载电容、-40~125℃温度条件下,此运放的直流开环增益大于80 dB,单位增益带宽大于170.74 MHz,转换速率大于150 V/μm,静态电流最大为5.8 mA。此运放的版图面积很小,仅为0.017 mm2,通过寄生参数的提取进行了后仿真,其结果和前仿真结果拟合得很好。

关键词: AB类;全差分;全工艺角

Abstract: This paper presented a high-speed class-AB fully-differential operational amplifier. Modified from traditional two-stage single-ended structure, it becomes a class-AB input and output fully differential operational amplifier. The bandwidth and slew rate were improved without decreasing the gain. The amplifier was designed on JAZZ 0.18μm CMOS process, To ensure the robustness, the simulation covered all the process corners. The results showed that the dc open-loop gain was over 80 dB, the UGF was over 170.74 MHz, the slew rate was over 150 V/μm, the quiescent current was less than 5.8 mA on the 3.3 V±10% supply voltage, 5 pF load capacitor and the temperature of -40~125℃. The layout area is very small which is only 0.017 mm2. After extracting the parasitic parameters, the post-simulation results showed it was well matched with the schematic level simulation.

Key words: class-AB; fully-differential; all the process corners

中图分类号: