中国半导体行业协会封装分会会刊

中国电子学会电子制造与封装技术分会会刊

导航

电子与封装 ›› 2018, Vol. 18 ›› Issue (4): 18 -21. doi: 10.16257/j.cnki.1681-1070.2018.0040

• 电路设计 • 上一篇    下一篇

一种基于FPGA加速配置的设计

庄雪亚,蔡翔   

  1. 中国电子科技集团公司第五十八研究所,江苏无锡 21407
  • 收稿日期:2017-11-20 出版日期:2018-04-24 发布日期:2018-04-24
  • 作者简介:庄雪亚(1986—),男,本科,江苏江阴人,工程师,研究方向为千万门级FPGA设计与验证。

A Design of Accelerated Configuration Based on FPGA

ZHUANG Xueya,CAI Xiang   

  1. China Electronic Technlogy Group Corporation No.58 Research Institute,Wuxi 214072,China
  • Received:2017-11-20 Online:2018-04-24 Published:2018-04-24

摘要: 随着设计工艺的飞速发展,FPGA的规模也越做越大,对FPGA的配置速度提出了更高的要求。基于FPGA,采用先配置空闲资源配置位、再配置需用资源配置位的策略,设计了地址解析模块、数据移位寄存器、控制系统等模块,完成了加速配置的设计,其配置速度快,配置数据小,兼容性强。通过数字仿真波形分析,验证了设计方法的可行性和正确性。

关键词: FPGA, 加速, 配置, 空闲资源, 需用资源

Abstract: With the rapid development of the design process,the size of the FPGA is getting bigger and bigger,putting forward higher requirements on the FPGA configuration speed.Based on FPGA,we using the strategy of configuring idle resource configuration bits first,then configuring the required resource bits,using the structure of address resolution module,data shift register and control system to complete the configuration of accelerated configuration.The configuration speed is fast,Configuration data is small,strong compatibility.The feasibility and correctness of the design method is proved through the analysis of corresponding digital simulation wave form.

Key words: FPGA, acceleration, configuration, idle resource, required resource

中图分类号: